You have to accept our privacy policy to send your request.
You have to accept our privacy policy to send your request.
Ask a question
Area of interest
Sign in
This is a very simple distributor consisting of a header and lateral assembly. It requires very little column height and provides high open area resulting in very low pressure drop. It does not provide very high distribution quality, and thus, finds limited applications. The main header is flanged at one end and clamped to a column wall clip at the opposite end.
Selection criteria*:
• Column diameter >250 mm (10 inches)
• Maximum Turn-down ratio 3:1
• Liquid rates: 4.0-25 m3/m2hr (1.0-10.25 GPM/ft2)
• Clean service
*Selection criteria guidelines provided are typical but not limiting. Under certain conditions, special design provisions can be made for accommodating varied hydraulic and mechanical requirements.
User identification is invalid
Ups! Something went wrong. Please try again later.
Forgot password?
User identification is invalid
Ups! Something went wrong. Please try again later.
Check your email within a couple of minutes to reset your password, if you can’t see any incoming messages try to check into your spam folder!